The entry to professional in ear personal monitoring from Shure. This package contains SE-112 Sound Isolating earphones, a P2R receiver and a P2T transmixer.
WHY IS IN EAR MONITORING MORE EFFECTIVE THAN USING A WEDGE SPEAKER ON STAGE?
Using a Shure monitoring system allows you to hear the music via your earphones at the exact time it is played. There can be a short delay in music coming out of the wedge, which can cause performers to play out of time. Wedge monitors will sound fine when standing in one position, but if you move to the left or right, that sound is likely to change. With in ear personal monitoring, the sound will be constant and comes with you, wherever you go. Using wedge monitors long term can also be damaging to your ears. Using Shure sound isolating earphones cuts out the sound around you leaving you to focus on playing in time.
HOW DO I SET UP MY PSM 200 IN EAR SYSTEM?
Simply connect two line-level or mic–level inputs directly into the transmixer. Set the frequency on the transmixer using a single button, and the same again on the bodypack receiver. Connect your earphones to the P2R, set up your desired mix using the personal mix controls on the front of the transmixer and you are now all ready to go.
Built-in audio limiter
Front mounted antenna
Two mic/line input channels for mix control
Built in headphone limiter
Volume control on bodypack receiver
1/2 Rack space
RF Output Power: 10 - 30 mW (countryspecific)
Operating Distance: Up to 100 m
Harmonic distortion: 1.5 % typical
Signal-to-noise-ratio: 80 dB (A) typical
Listening mode: Mono
Compatible Systems per band (up to): 4
Transmitter Inputs: 2x XLR/6,3 mm combo, mic/line level
Transmitter Outputs: 2x XLR split outputs
Wired Bodypack Option: Yes
Personal Mix Control: On transmitter
Remoteable Transmitter: No
Battery Life: Wired: 6 h; Wireless: 4 h
Frequency Response: 30 Hz - 12 kHz
Further technical specifications:
RF Carrier Frequency Range: 518-865 MHz (country dependent)
Modulation: FM +/- 35 kHz Deviation (Nominal)
Operating Temperature: -7 degrees C to +49 degrees C (+20 degrees F to +120 degrees F)
Modulation Limiter: Internal peak limiter (>10:1 hard knee compression)